Ammonia is drawing renewed attention as a “magic container” for safely storing and transporting hydrogen, a promising clean energy source of the future, as well as a carbon-free fuel that does not emit greenhouse gases when burned. However, for ammonia to be widely used as a key fuel, improving the efficiency of its production process is essential. A Korean research team has presented a new approach that enables ammonia to be produced rapidly and in large quantities while using far less expensive and scarce precious-metal catalyst.
KAIST (President Choongsik Bae) announced on the 19th of November that a research team led by Professor Minkee Choi from the Department of Chemical and Biomolecular Engineering greatly improved metal-use efficiency by reducing the particle size of ruthenium (Ru) catalysts used for ammonia synthesis.
Ammonia has long been used as a key raw material for fertilizers, but recently it has attracted even greater attention as a critical material connecting the hydrogen economy. This is because converting gaseous hydrogen into ammonia makes it much easier to store and transport, after which hydrogen can be extracted again when needed or ammonia itself can be used directly as a fuel. However, conventional ammonia production requires extremely high temperatures and pressures, resulting in high energy consumption.
Ruthenium (Ru), a metal that exhibits excellent performance in ammonia synthesis, is an expensive and scarce precious metal. It is therefore important to achieve high productivity using as little ruthenium as possible.
The research team found a solution by dividing the precious metal into extremely small particles. In general, when metal particles are made smaller, their surface area increases, naturally creating more sites that can participate in chemical reactions.
The researchers newly revealed that as the particles become smaller, each individual reaction site itself also becomes significantly more active. The key lies in an “electron promotion effect.” To produce ammonia, the strong bond between nitrogen atoms in nitrogen molecules must be broken, and an electron-rich catalyst actively facilitates this process.
The research team further conducted comparative experiments by adding barium oxide (BaO), which helps supply electrons, to ruthenium (Ru) catalysts of different particle sizes. The results showed that as the particle size decreased, electrons transferred much more effectively from barium oxide (BaO) to the ruthenium (Ru) surface, maximizing the “electron promotion effect.” The increased abundance of electrons on the catalyst surface made it easier to break the bonds in nitrogen molecules, greatly accelerating the ammonia synthesis reaction.
In particular, a catalyst with a particle size of 1 nanometer (nm) achieved an ammonia synthesis rate per reaction site 4.4 times higher than that of a 10 nm catalyst. As a result, two effects occurred simultaneously: the number of available reaction sites increased, and the performance of each individual site improved. Consequently, when the same amount of ruthenium (Ru) was used, the overall ammonia production rate increased by as much as 57-fold, dramatically improving production efficiency relative to the amount of precious metal used.
Professor Minkee Choi said, “This study identifies a principle for increasing ammonia productivity by using expensive precious metals more efficiently.” He added, “Going forward, we will extend this work to develop catalysts that enable ammonia production with lower energy consumption, even at low temperatures and pressures.”
Yaejun Baik, a Ph.D. student in the KAIST Department of Chemical and Biomolecular Engineering, led the study as the first author, while Professor Minkee Choi participated as the corresponding author. The research findings were published online on June 17 in the
Journal of the American Chemical Society (JACS), a leading international journal in chemistry.
※ Paper title: Beyond Geometric Effects: Particle Size-Dependent Electronic Promotion in Ru Catalysts for Ammonia Synthesis, DOI:
https://doi.org/10.1021/jacs.6c06515
This research was supported by a research program of the National Research Council of Science & Technology (NST), funded by the Ministry of Science and ICT.